1KG ABS2.0 Filament Refill - Seismic Red
A red filament for everyday use.
This filament uses low warp technology. Many others have created "gimmicks" to low warp by mixing other polymers to reduce the warping. This new ABS technology is truly low - no warp without the use of modifiers or fillers. It also doesn't smoke or smell when printed.

*NOTE* You must print the refillable spool below to use the refill coils
The refillable spool can be found on Thangs
Appearance: Gloss
Resin: ABS2.0
Extrusion Temp: 255c@65mm/s
Flow Rate: 30 - 65mm/s
Bed Temp: 90c - 100c (with PEI / Ultem, or Glass with Hairspray or Glue Stick)
Diameter: 1.75mm