1KG ABS1.5 Filament Refill - Electrolytic Deuterium
Fusion Filaments
Regular price
$0.00
$29.99
A super sparkle sky blue.
*NOTE* You must print the refillable spool below to use the refill coils
The refillable spool can be found on Thangs
Appearance: Matte
Resin: ABS1.5
Extrusion Temp: 245c@65mm/s
Flow Rate: 30 - 65mm/s
Bed Temp: 90c - 100c (with PEI / Ultem, or Glass with Hairspray or Glue Stick)
Diameter: 1.75mm
- Print the refill spool above
- Cut open the vacuum sealed bag the filament came in, and remove the paper discs covering the top and bottom of the coil. Do not remove the cardboard core
- Leave the 4 paper straps in place, and slide the coil onto the 3d printed spool, NOTE* Coils fit very snug!, apply even pressure all the way around and they will slide on perfectly
- Lock the two sides of the refill spool together (the snap together mechanism is very tough, it will take some force to snap together)
- Cut the paper straps (some paper will remain inside the spool core, this is ok)
- Filament is ready for use
Customer Reviews
Based on 1 review
Write a review